Par-Kan Grain-Weigh GW200A, Руководство пользователя

Страница: 13 / 35

13
Grain Weigh 200A Hydraulic Trouble Shooting
1. Hydraulics will not operate.
-
Make sure the engine is running at full power and not on one cylinder. Make sure the vent
on the gas cap is open for engine to receive fuel.
-
Check for blown fuse behind the weigh head and or see the manual override procedure.
-
Visually check to see that there is the correct amount of hydraulic oil.
1. If the auger will not raise or lower.
-
Make sure the engine is running in the normal rpm range. (3,000 rpm)
-
Adjust the flow control valve on the backside of the manifold.
1. If the auger is not raising or lowering smoothly.
-
Make sure the engine is running in the normal rpm range. (3,000 rpm)
-
Adjust the flow control valve on the backside of the manifold.
The pre set adjustment for this flow control valve has been set as follows: Twist knob clockwise
until snug, then twist counterclockwise 2 full revolutions and tighten down with 5/64” Allen
wrench.