Paoli SUPERSPORT NEXTGEN, Руководство по эксплуатации и техническому обслуживанию

Страница: 4 / 32

ENGLISH
OPERATING AND MAINTENANCE MANUAL
4
L
It is recommended to use a whip hose (flexible
hose for compressed air with a minimum
length of 46 cm (18 inch)) with a threaded male
to connected to the air inlet of the wheel gun,
and a male quick disconnect coupling at the
other end.
L
Fit a the whip hose to the air pressure regulator
using a specific supply hose.
L
Use a supply pipe of minimum inner diameter
13 mm (1/2 inch) suitable for its intended use,
and crimped with 1/2” BSP fittings.
L
Use couplings with minimal nominal bore 10
mm (25/64 inch) suitable for their intended use.
L
It is recommended to use a high pressure oiler
to constantly lubricate the motor and keep
steady the wheel gun speed.
View figure Fig.3.
L
It is allowed to use exclusively on industrial
plants with compressed air.
L
Make use of a supply system that observes the
indicated pressure values (max 10% over the
maximum value indicated) using an air pressure
regulator supplied by a system observing the
current safety standard, and that it is subjected
to regular checks.
L
The components of the supply system must be
designed and constructed in accordance with
the safety requirements contained in current
international standards.
L
Before any work on the supply system, always
check that the line is depressurized (no air
pressure).
AIR SUPPLY SYSTEM DIAGRAM
DESCRIPTION
Portable air impact wrench designed for
motorsport application (Best Practice: NASCAR
CUP SERIES, GT).
LUBRICANT
Hammer mechanism lubrication: Special
grease for Paoli air impact wrench hammer
mechanism.
Air motor lubrication: Very fluid oil for air
tools or Special oil for Paoli air impact wrench
motors.
ENVIRONMENTAL CONDITIONS
Temperature: -5 ° C ÷ + 45 ° C
Storage temperature: 0 ° C ÷ + 40 ° C
Air humidity: <80%
Max Altitude: 2000m from sea level
INTENDED USE
Assembly air tool for threaded fasteners in the
pit stop service.
TECHNICAL DATA
Weight (kg)
4,03
Length (mm)
202
Drive shaft
Spline
Air inlet
3/8” BSP
Supply hose inside diameter
1/2” (13 mm)
Maximum free speed (RPM)
11.500** (at 25 bar)
Max weight recommended
power socket (kg)
0,70
Operating air pressure (bar)
25 (maximum)
Ultimate torque* (Nm)
2.800**
* These performances have been obtained after having tested the wheel gun on a testing-bench, that is on fixed
bolts, which have been tightened for 3 seconds. Please remind that, during the tightening/loosening on a Formula 1
car’s wheel hub you lose most of the torque, due to the hub’s spin. Furthermore the performances change depending
on the wheel gun’s operating-time on each nut, reminding that the correct operating-time on one single nut is, on
average, less than one second.
** SUPERSPORT NEXTGEN Unhanded (UH) version: Maximum free speed is 11.000 RPM (at 25 bar) - Ultimate torque is
2.800 Nm.