Paoli DP 4000 30BAR, Руководство по эксплуатации и техническому обслуживанию

Страница: 5 / 64

ENGLISH
OPERATING AND MAINTENANCE MANUAL
5
L
Do not use the wheel gun with the screws
of the clutch cover (view figure Fig.1-E )
or the motor cover ( view figure Fig.1-P )
loose or not tight enough ( see table Tab.
A “Tightening Torques” ). If not tighten
them with a torque wrench following the
tightening sequence shown ( view figures
Fig.2-F and Fig.2-G ).
L
Pay attention to the exhaust coming out
by the wheel gun during operation ( view
figure Fig.2-B ). To avoid compromise the
performance of the wheel gun, not obstructed
in any case these holes of exhaust.
L
Wheel gun intended to be used for
professional use by trained personnel and
equipped with appropriate technical skills.
L
Do not operate the wheel gun without the
prescribed safety devices.
L
The drive shaft of the wheel gun and the
socket fixed to it may continue to rotate for
a short time after the release of the trigger.
L
Verify that the WARNING label ( view figure
Fig.1-W ) is present and legible, otherwise
replace it by applying new one in the original
position.
GENERAL INSTRUCTIONS
Original operating instructions -
The original language of these instructions is English.
L
Always use a wheel gun with the tightening
torque corresponding to the one required
by the application.
L
Please pay attention to your wheel gun
version:
⚪ the Fast Left Hand (LH) version loosens
nuts tightened clockwise faster;
⚪ the Fast Right Hand (RH) version loosens
nuts tightened anticlockwise faster;
⚪ the Unhanded (UH) version loosens at
same speed both the nuts tightened
clockwise and anticlockwise.
L
In order not to compromise the
functionality of the rotation reverse shaft,
do not unscrew or loosen never the grub
screw of the motor cover ( view figure
Fig.2-D ).
L
The standard adjustment of the force necessary
for the translation of the rotation reverse shaft,
and thus the reverse is already performed
by Dino Paoli s.r.l.. A personalized set of this
force is possible, however, for specific needs
of the operator, acting uniformly on the nr.2
(two) rotation reverser grub screws ( view figure
Fig.2-C ). Tightening the grub screws you will
have an increase in the force required, loosening
them you will have its decrease. Ensure that the
individual regulation does not create problems
of accidental reversal of the direction of rotation.
Perform this adjustment always disconnected
the wheel gun from the air supply.
L
The modes for the correct grip intended
for use of the wheel gun is as follows (view
figure Fig.2-E ):
⚪
right hand grip on the gun body;
⚪ left hand grip on the surface of the hammer
case.
OPERATING INSTRUCTIONS
TAB. A
TIGHTENING TORQUES
Clutch Cover
M6 Screw 22 Nm (with Nord-Lock
®
washers)
Motor Cover
M5 Screw 12 Nm (with Nord-Lock
®
washers)