9
art.nr
.bruk-S3-eng, Rev
. 2016-02
Panthera
AB reserves the right to make technical changes if required
SETTINGS
1) The tension of the seat upholstery
(Fig. 6)
The rear section of the seat upholstery can be tightened or loosened by adjusting the
Velcro strap underneath.
This allows you to vary your seat height by around 2 cm upwards or downwards. The seat
should be used together with a seat cushion.
2) The height of the footrest
(Fig. 7)
The footrest can be adjusted either upwards or downwards.
You should adjust the footrest at a height where your thighs are supported by the seat at
the same time as your feet are supported by the footplates or foot support.
Adjusting the height of the footrest
:
1) Remove the two screws supporting the footrest on the front of the frame using a 3 mm
Allen key.
2) You can then move the footrest up or down to fit into one of the fixed positions.
3) Securely tighten the two screws.
3) The tension of the calf strap/heel strap
(Fig. 8 and 9)
The tension of the calf strap and heel strap will determine how far forward you can place
your feet on the foot support or footplates, respectively. The suitable tension depends
largely on how long or short your legs are.
Adjusting the tension of the calf strap/heel strap
(Fig. 8 and 9)
1) Loosen the calf strap/heel strap.
2) Place your feet on the foot support/footplates.
3) Adjust the tension of the calf strap/heel strap using the Velcro strap provided.
Fig. 7
Fig. 6
