128-9105
8 of 20
Page 8
Second Vehicle Operation:
Press the Trunk/Key the Option button for 2 seconds, the LED flashes 2 times.
Release the buttons, then press any transmitter to select 2nd vehicle mode.
While in the 2nd car mode, press the Trunk/Key Option button for 2 seconds, the
LED flashes 1 time to indicate the primary vehicle operation.
DELETING TRANSMITTERS FROM YOUR SYSTEM:
It may be necessary to delete a lost transmitter or to reprioritize a transmitter that is pro-
grammed to your system. To remove a transmitter that has been programmed in your
system:
1) Enter the transmitter program mode of channel 1 as indicated above.
2) Press and hold any transmitter button that has not been programmed into channel 1 until
you hear a chirp, then release and immediately press the same button a second time until
you hear a long chirp followed by a short chirp. This action erases the transmitter.
If the transmitter you wish to erase has been lost or stolen then following the information
below will successfully remove the transmitter.
NOTE: For this procedure, you must have all transmitters you wish to remain programmed in
your system available.
1) Enter the transmitter program mode of channel 1 as indicated above.
2) Press and hold the lock button of each transmitter you wish to operate the lock function of
your unit making sure you occupy all 4 transmitter slots. In other words, you have three
transmitters you wish to remain programmed. Press and hold the lock button of transmitter
one until a long chirp is heard, then press and hold the lock button of transmitter two, then
press and hold the lock button of transmitter three, followed by pressing and holding the lock
button of transmitter one again. This action fills all 4 receiver slots.
3) Advance to receiver channel 2 by pressing the pushbutton switch one time.
4) Press and hold the unlock button of each transmitter you wish to operate the unlock
function of your vehicle, again making sure all 4 transmitter slots are filled.
4) Advance to receiver channel 3 by pressing the pushbutton switch one time.
5) Press and hold the unlock button of each transmitter you wish to operate the start function
of your vehicle, again making sure all 4 transmitter slots are filled.
If you are uncomfortable about the programming of additional transmitters as outlined in the
processes above please contact your installation center or call the technical service number
listed on the back of the transmitter for help.
BATTERY REPLACEMENT (PA91 Uses 2 x CR2016 Lithium Battery)
The transmitter incorporates a small LED visible through the case which
is used to indicate battery condition. You will notice a decrease in
transmitter range as the battery condition deteriorates. Transmit-
ter battery replacement is recommended at least every 10 to 12 months,
depending upon how frequently the transmitter is used.
To replace the battery in the PA91 Transmitter
1) Carefully Separate the transmitter case using the edge of a coin as
shown.
2) Remove the rear cover to access the discharged battery
paying attention to the proper polarity orientation.
3) Carefully remove and properly dispose of the discharged
battery.
4) Insert the new battery, than carefully snap closed the transmitter
case.
5) If you accidently dislodge the circuit board from the transmitter
housing, be certain that the rubber membrane is seated properly, and
the buttons are properly exposed from the front view of the case,
then insert the circuit board, and return to step #4.
