128-9105
4 of 20
Page 4
MANUALLY OVERRIDING YOUR SYSTEM:
USING THE CUSTOM CODE OVERRIDE
Assuming the override code programmed has not been changed, and the default override
code of 11 is in the system's memory.
1. Enter the vehicle and turn the ignition switch to the on position.
NOTE:
The siren will sound.
2. Within 5 seconds, press and release the pushbutton switch 1 time.
3. Within 5 seconds, turn the ignition switch off then on.
4. Within 5 seconds, press and release the pushbutton switch 1 time.
5. Turn the ignition switch off then on and start the vehicle.
NOTE:
If you have changed the programmed override code then substitute your new code
tenths for step 2 above, and units for step 4 above.
PUSHBUTTON VALET/SAFETY CONTROL/PROGRAM SWITCH
The Push-Button valet safety control switch allows you to temporarily disable the remote start-
ing function of the system. This is recommended whenever the vehicle is being serviced. To
place the system in the service/temporary disabled mode:
1) With the system disarmed/unlocked, and the ignition switch off Press and Hold the Push-
Button Switch on.
2) Turn the ignition switch on, off, on, off, on, off.
3) The LED begins to flash two short flashes followed by one long flashes and continues
this pattern until returned to normal mode of operation.
This puts the unit into the R/S Override mode indicating that the remote start system is in the
service/temporary disabled mode and will not start from RF or any other input Telematic
input or otherwise.
To Exit R/S Override Mode
1) With the system disarmed, Press and Hold the Push-Button Switch on.
2) Turn the ignition switch on, off, on, off, on, off.
3) The LED turns off indicating that the R/S unit is fully functional one again.
REMOTE CAR FINDER/PANIC
The Lock or Unlock buttons are also used to access the car finder/panic mode. This feature is
particularly useful in a crowded parking lot where finding your car may be difficult to locate, or if
there are suspicious characters hanging about your vehicle. To access this mode, while within
range of your car, simply press and hold either the lock or unlock button of your transmitter for
three seconds. The parking lights will begin to flash, the siren will sound, and if connected,
the vehicle horn will beep making your vehicle audible as well as more visible. The lights,
siren and or horn will stop automatically after 30 seconds. If you wish to turn off this mode
prior to the expiration of the 30 second timer, press and hold for three seconds either the lock
or unlock buttons a second time, or press and release the Trunk/Start button one time.
REMOTE TRUNK RELEASE
If you have electric trunk release in your vehicle and the remote trunk release option was
added, simply press and hold the Key/Trunk button of your keychain transmitter for 3
seconds or until the electric trunk of your vehicle opens.
REMOTE STARTING THE VEHICLE
This unit will not start the vehicle if any one of the following situations exists;
The vehicle's hood lid is opened. The gear shift selector is not in Park.
The brake pedal is depressed. The system is in the remote start override mode.
1. To start the vehicle, press and release the Key/Trunk button two times within 2 seconds. The
vehicle will start and remain running for the pre-programmed 5,10,15,20 minute run cycle.
As a visual indication, the parking lights will flash or remain on depending on the setting by
your installation center.
