Motorized Screen Set-Up Guide |
SETTING THE UP LIMIT POSITION
CAUTION: Do not allow the slat bar to become wedged between the roller
and case. This could damage the fabric and motor. Always check that the slat
is free to move inside the case.
If the screen travels too far into the case:
Make sure the middle fastening screw (F) is loosened, then loosen the small
left fastening screw (FL). Turn the left screw (LS) clockwise to decrease the
amount of travel. Run the screen up to test the stop position. If the screen
does not stop properly, adjust the limit switch again. Repeat until the desired
position is set. When completed, fasten the middle fastening Screw (F) and
small left fastening screw (FL).
If the screen does not travel far enough into the case:
Make sure the middle fastening screw (F) is loosened, then loosen the small
left fastening screw (FL). Turn the left screw (LS) counterclockwise to increase
the amount of up travel. Run the screen up to test the stop position. If more
travel is desired, adjust the limit switch again. Repeat until the desired
position is set. When completed, fasten middle Fasten Screw (F) and small
left fasten screw (FL).
