© Panduit Corp. 2018
INSTRUCTION MANUAL
VeriSafe AVT
B21052_05
Page: 18 of 20
4-2018
Maintenance
Warning:
•
The product uses a lithium battery that is a fire, explosion and severe burn hazard. Do not crush, recharge,
disassemble or heat above 85
°
C, incinerate, or expose contents to water.
•
Battery, AVT System Cable and O-rings can be replaced. No other part of the product is serviceable. Do not
attempt to open the Indicator Module or Isolation Module for repair or modification. When servicing this product,
only use specified replacement parts.
•
The AVT will not work with a standard alkaline 1.5Volt AA battery. Use only approved batteries listed in table
shown in the Maintenance section of this instruction manual.
Battery Replacement
F
ollow these steps to replace the battery. Table 1 provides a list of batteries approved for use with the AVT. Do not discard
the battery in the trash; take it to an appropriate battery recycling facility.
Manufacturer
Model Number
Size
Description
Tadiran
TL-5903
AA, ER14505
3.6 Volt Lithium Battery
Xeno Energy
XLP-060F
Saft
LS14500
Table 1: Approved VeriSafe AVT batteries
1.
Grip the Indicator Module
Cap.
2.
Twist the Indicator Module cap
counterclockwise approximately 90
degrees, until you feel a stop.
3.
Remove the cap.
4.
Grip the battery tray and
slide it out until you feel a
stop. The battery tray is not
intended to be fully
removed.
5.
Remove used battery.
Dispose according to local
procedures.
Install a new battery. The
positive terminal should
face the operator.
6.
Slide the battery tray back in the
housing.
A self test is initiated when the
battery tray is inserted and
connection is made between the
battery and AVT electronics.
7.
Replace the cap.
8.
Twist cap clockwise to lock
into place.
Record the date the battery
was replaced in equipment
documentation.
