SETTING UP THE PANTHER LS8E
AND USING FILE MANAGER
33
Label Modes
To edit the label mode, press the LABEL key.
1. Use the up or down directional arrows to select the desired mode and then
press
.
Available Modes include:
MODE
DESCRIPTION
APPLICATIONS
Component
Vertically centers legend
Electrical components
Wiremarker
Repeats legend until label is filled
Wire and cable marking
Terminal
Places legends at terminal locations
Terminal blocks
Tape
Rotates legends 90° clockwise
Safety/facility ID, pipe
marking
Strip
Repeats legend until label is filled
and copies legend on two sides of
middle perforation
Wire and cable marking
Network
Places legends at port locations
Data communications
components
Flag
Prints legend once at top of label
and then repeats the legend once at
the bottom of label
Wire and cable marking
Vertical
Prints legend vertically
Safety/facility ID, pipe
marking
NOTE: Another mode for DIN terminal block labeling is accessible by pressing
the F5 key. DIN terminal block labeling is based on European standards
and is primarily used in European countries. For detailed instructions on
using the DIN mode, refer to the Labeling Exercises section of this
manual on page 57.
Содержание LS8-PCKIT
