Page: 5 of 6
CT-930LPCH
Panduit Corp., Tinley Park, IL
DUST
CAP
RAM
SNAP
COUPLING
W
ARNING
DO NOT USE ON LIVE
ELECTRICAL
CIRCUITS
DIE RELEASE BUTTON
(FAR SIDE)
DIE RELEASE
BUTTON
TOOL HEAD
CHAIN
DUST
CAP
COUPLING
RAM
TOOL
HEAD
DIE CAVITY
DIE RELEASE BUTTONS
CT-940CH
HYDRAULIC COMPRESSION TOOL
TOOL OPERATION
(See figures above)
1. The CT-930CH and CT-940CH Tool Heads must be operated with a compatible hydraulic pump system, capable of
developing and sustaining 10,000 PSI (700 kg/cm2).
PANDUIT
's CT-901HP Hydraulic Pump and CT-900HPH High
Pressure Hose (electrically non-conductive; 10 foot long) is recommended. This system's fittings are matched to the
tool head fittings.
The CT-930LPCH Tool Head must be operated with a compatible hydraulic pump system, capable of developing and
sustaining 7,500 PSI (525 kg/cm2).
PANDUIT
's CT-8250HP Hydraulic Pump and CT-900LPHPH Low Pressure Hose
(electrically non-conductive; 10 foot long) is recommended. This system's fittings are matched to the tool head fittings.
2. The CT-930CH, CT-930LPCH and CT-940CH Tool Heads have been charged with hydraulic fluid at the factory.
Remove the dust cap from the connector coupling on the tool.
CAUTION:
Upon removing the dust cap, be sure to keep the hydraulic fittings on the tool head, hydraulic pump and
hydraulic hose free from contaminates. Failure to do so may lead to malfunction of the tool head and/or
hydraulic pump.
CT-930CH, CT-930LPCH and CT-940CH OPERATING INSTRUCTIONS
