CT-2600 and CT-2600/E
CT-2600 & CT-2600/E
PA26001A01_02
Page: 6 of 11
5-2009
CRIMP DIES AND ACCESSORIES
(sold separately)
CD-2600 Series Compression Dies
Consult
PANDUIT
catalog or website for part numbers and
specific die application information.
CT-2600BC
Replacement
Battery
Cartridge
CT-2500CHR
Replacement
Battery
Charger
CT-2500CHR/E
Replacement Battery Charger for Europe
Makita 7.2 Volt – 18.0 Volt
DC
replacement battery charger
Makita Part No.: DC1804
Makita 7.2 Volt – 18.0 Volt
DC
replacement battery charger for EU
Makita Part No.: DC1804F
Replacement Makita Batteries and Battery Chargers are available for purchase from local Makita
products distributors.
DIE SELECTION AND INSTALLATION
Refer to product packaging label to verify terminal to die combinations.
NOTE:
DIES ARE DESIGNED TO PROVIDE THE HIGHEST QUALITY CRIMPING WHEN USED WITH
PANDUIT
TERMINALS. CONNECTIONS UTILIZING THIS TOOL ARE LISTED PER U.L. 486A AND
C.S.A. CERTIFIED ONLY WHEN
PANDUIT
TERMINALS ARE USED. USE OF ANY OTHER BRAND
OF TERMINALS IS NOT RECOMMENDED WITH CD-2600 DIES.
NOTE: Remove battery from tool before removing or installing dies in the crimp head.
1.
Remove any current dies from the tool ram by opening locking flange in crimp head and pulling die
out of tool.
CAUTION: Do Not
let the ram contact the crimp head.
2.
Select the appropriate dies to match the terminal to be crimped.
1.
Slide one of the die halves into the crimp head until it snaps into place.
2.
Properly position the remaining die half into the crimp head until it snaps into place, and close the
locking flange.
3.
Replace the battery and slowly activate the tool to ensure that the die halves are properly aligned
without binding or interference in the crimp head.
NOTE: DO NOT operate tool if dies are not properly aligned and snapped (locked) in place.
