AT-OME-PS62
28
webGUI
Display
Select Display from the top navigation to adjust display control settings.
NOTE:
The Display page is only available when Matrix mode is disabled.
CEC Command HDBaseT and HDMI
Power
- Using CEC protocol, the PS62 will send the on and off commands out the HDMI outputs of the PS62
and compatible HDBaseT receiver.
Volume
- Pressing these buttons will send the CEC commands for volume up, down, and mute, out the HDMI
outputs of the PS62 and compatible HDBaseT receiver.
System Settings
Display Auto Power
- Enable to send the programmed command to the display to turn on or off when detecting or
losing A/V signals.
Auto power off timer
- Sets the period of time between the loss of A/V signal and when the display off command
is sent. Default is 15 seconds and can be adjusted from 5 seconds to 1 hour.
Lamp cool down timer (Sec.)
- Sets the time between when projector lamp has been turned off to when it can
receive new commands. Default is 10 seconds and can be adjusted from 10 seconds to 300 seconds.
Display Warm-Up Timer (Sec.)
- Sets the time between when the projector lamp has been turned on to when it
can receive new commands. Default is 10 seconds and can be adjusted from 10 seconds to 300 seconds.
Control Type
- By default, CEC is selected for control of the display. IP and RS-232 can also be selected. When
IP or RS-232 are selected, more fields are available.
