Panduit Atlona AT-HDVS-150-TX-HDMI, Руководство пользователя, Страница: 15 / 27

AT-HDVS-150-TX / AT-HDVS-150-TX-PSK 15
The AT-HDVS-150-TX provides auto-switching capability between HDMI IN 1 and HDMI IN 2, which will automatically
switch the input to the most recently-connected or powered source when a source is disconnected. For example,
if the connection sequence is HDMI 2 > HDMI 1 , and a source is disconnected from HDMI 1 , then the AT-HDVS-
150-TX will automatically switch to the HDMI 2 . Auto-switching mode is enabled or disabled through the on-screen
display (OSD) menu system, and is enabled (On), by default.
Input Auto Switching
1. Connect a category cable from the HDBaseT OUT port on the AT-HDVS-150-TX to the HDBaseT IN port on the
AT-HDVS-150-RX using a category cable (CAT-5e or better). The category cable should not exceed 230 feet (70
meters) in length.
The AT-HDVS-150-RX must be connected to the AT-HDVS-150-TX, in order to manage auto switching.
AT-HDVS-150-TX
AT-HDVS-150-RX
HDBaseT IN FW DC 48V
+
HDMI OUT AUDIO OUT
L R
RX TX
RS-232
MENU
V
V
PW
LINK
2. Connect an HDMI cable from the HDMI OUT port on the AT-HDVS-150-RX to a display.
HDBaseT IN FW DC 48V
+
HDMI OUT AUDIO OUT
L R
RX TX
RS-232 MENU V
V
PW
LINK
to Display
NOTE: Auto-switching is triggered by a Hot-Plug Detect (HPD) event. If HPD is not detected,
then AT-HDVS-150-TX will not switch inputs. VGA does not support HPD. Therefore, the VGA port
cannot be used in the auto-switching cycle.
3. Press the MENU button on the front panel of the AT-HDVS-150-RX to display the on-screen display (OSD) menu
system.
HDBaseT IN FW DC 48V
+
HDMI OUT AUDIO OUT
L R
RX TX
RS-232 MENU V
V
PW
LINK
Solution Setup and Configuration Guide