23
22
U S E R MA N UA L
PA N D O R A S MA R T V3
Enabling/disabling automatic engine starts
Pandora systems have a function of prompt disabling automatic engine start:
1. Call the system number and wait for the answer.
2. Dial 987* to disable all automatic engine starts or 789* to enable.
3. The system will confirm execution of the command.
To end the session, hang up the phone.
Automatic starts can be enabled again by dialing 789* (all previous settings will remain intact).
Request current coordinates
1. Call the system number. Wait for the answer.
2. Dial 500*.
3. The system will confirm: «Current coordinates are sent via text message» and will send a message
with LBS and GPS/GLONASS coordinates at your phone.
To end the session, hang up the phone.
Request GSM balance
1. Call the system number. Wait for the answer.
2. Dial 100*.
3. The system will confirm: «Balance information is sent via text message» and will send text message
with account balance information to your phone.
To end the session, hang up the phone.
Tow truck mode
This mode is intended for car transportation with preservation of arming function. Tow truck mode
can be activated only when the system is armed, it will be deactivated automatically when disarming.
1. Call the system number. If the system is in PANIC mode, receive an emergency call. Wait for the
answer.
2. Dial 15* , to enable the «Tow truck» mode, the system will disable motion, shock and tilt sensors.
To end the session, hung up the phone.
3. To disable this mode, disarm the system.
Activating/Deactivating engine blocking
You can block a car engine using any phone. The engine will remain blocked until phone command
«Unlock engine» will be sent and the «Secret PIN-code» will be entered. This blocking cannot be
disabled by any other means.
1. Call the system number and wait for the answer.
2. Dial 666* to block an engine or 999* to unlock it (after dialing 999* you should enter the «Secret
PIN code» that is located on the owner’s card).
!
a
ll
oTher
commands
can
be
enTered
in
The
same
manner
.
Changing settings via a phone
Disarm the system, call the system number, wait for the answer, switch on the ignition for 1-3
seconds (but no more than 5 seconds), then switch it off. The system will enter the settings mode.
An example of changing the owner’s system number:
1. Enter the setting menu via a phone according to the instruction above;
2. Dial DTMF command 1*(phone number settings) and 1*(owner’s system number);
3. Enter new owner’s number in the format *XXXXXXXXXXX # (the system recognizes «*» as «+»);
4. To confirm, dial 1*.
!
T
here
are
2
ways
To
change
main
owner
’
s
phone
number
1. v
ia
a
phone
,
using
dTmf
commands
seTTings
mode
.
2. u
sing
radio
Tags
:
Turn
on
The
igniTion
when
The
sysTem
is
disarmed
and
call
The
sysTem
phone
number
. w
aiT
for
The
answer
,
dial
The
«g
uesT
pin-
code
» (
defaulT
value
is
1-2-3-4)
if
you
are
calling
noT
from
The
main
owner
’
s
number
,
Then
press
and
hold
The
buTTon
on
The
radio
Tag
for
2
seconds
(
unTil
The
second
flash
of
The
send
indicaTor
). r
elease
The
buTTon
,
The
sysTem
will
recognize
The
incoming
phone
number
as
The
«m
ain
owner
’
s
phone
number
».