Pandora Smart Moto, Руководство пользователя

Страница: 41 / 56

41 USER AND INSTALLATION MANUAL
Emergency disarming
Not paying attention to the siren signals, make sure that the ignition is off and enter the «Secret PIN-
code» (see the procedure description above). If there are no siren sounds or LED flashes, check the
battery. It is not possible to enter the «Secret PIN-code», if there is no power supply.
• The system will be disarmed in case of correct PIN-code input. It will be confirmed with the series of
green and red flashes of the LED indicator, the series of sound signals of the Beeper, 4 beeps of the
Siren and 4 signals of the light signalization.
• Emergency disarming is equivalent to a normal method of disarming. No additional actions are
required for further operation of the system.
• The system will stay in previous state in case of incorrect input of the PIN-code. It will be indicated
with a long red flash of the LED indicator. New input can be attempted after 5 seconds.
Emergency control of the Code Immobiliser
This section describes two options to deactivate Immobiliser modes:
• Immobiliser and Anti-hi-Jack - use owner authorization devices (tags, remotes, watches, bands) for
engine blocking;
• Code Immobiliser - uses standard vehicle controls (buttons, levers, pedals) to enter the Immobiliser
PIN-code.
OPTION №1 – Emergency deactivation of the Code Immobiliser
To temporarily deactivate the Code Immobiliser (pin-to-drive) function, turn on the ignition when the
system is disarmed and Service mode disabled. Enter the «Secret PIN-code» from the Owner’s personal
card using the VALE T button. The Immobiliser functions will be deactivated by the time the ignition is
turned off.
OPTION №2 – Emergency control of the Code Immobiliser mode
This method is used for a permanent deactivation of the Code Immobiliser (pin-to-drive) function.
Deactivation and activation is made by entering the «Secret PIN-code» from the owner’s personal card
using the VALET button while system is disarmed, ignition is off and the Service mode is disabled.
1. Enter the programming mode by entering the «Secret PIN-code» (from the Owner’s personal
card) or the «Service PIN-code» (factory preset is 1-1-1-1). The PIN-code should be entered using the
external or located on the base unit VALET button.