39
U S E R M A N U A L
Level №0 – Entering a level
After entering programming mode, the system waits for level input – “Level 0 Entering a level”.
Enter a desired level using the VALET button (see the programming table) to change settings
or parameters:
• To enter a level, press the VALET button the number of times equals to the desired level number,
pauses between presses should not exceed 1 second. The system will confirm correct input with red
LED flashes and short sound signals of the siren/beeper and proceed to the desired level.
• For quick access to the higher level, press and hold the VALET button. The siren will sounds tone
beeps (up to 10). These sounds means the sequence number of a two-digit level number (the first
signal – level №10, the fifth signal – level №50, the tenth signal – level №100). Release the VALET
button immediately after the desired number of signal. To enter an intermediate level (Level
№11…№19 or №21…№28), press the VALET button the number of times equals to the second digit
(1…9) of the desired level number immediately after releasing the button. The system will confirm
correct input with red LED flashes and short sound signals of the siren/beeper and proceed to the
desired level.
Level №1 – Pairing control devices
Prepare to pair all Bluetooth devices - install batteries, turn on the devices in accordance with their
manuals. All previously paired devices will be removed when you pair new devices (tags and remote
control are in separate memory cell, so if you pair a new radio tag, the previously paired remote control
will be not removed and vice versa). Devices are paired one by one, in any order and without time limit.
Enter the programming level №1, the LED will be green:
• To pair a remote control, press and hold 3 buttons of a remote control (arm/disarm/F) simultaneously
for 1 second (until a short beep), then release the buttons;
• To pair a radio tag, press the control button on a tag and hold it for 6 seconds (6 flashes of the tag
status indicator), release the button after the sixth flash;
- If pairing of any device was successful, the siren/beeper will sound a beep
- Press the VALET button once to pair the next device or to finish pairing (the LED indicator will
confirm it with the series of green and red flashes and the beeper will confirm it with the series of sound
signals), the system will go to the programming level №0.
Level №2 – Changing the Service PIN-code
Prepare a new value of the “Service PIN-code, it should consist of 4 digits (from 1 to 9). Write down
or remember the new PIN-code.
Содержание SMART MOTO V2
Страница 45: ...45 USER MANUAL...
Страница 46: ...46 PANDORA SMART MOTO V2...