37
U S E R M A N U A L
Entering/Exiting programming mode
You can enter the programming mode only if the base unit is powered form a USB cable or the main
power supply is connected, the ignition is off, the system is disarmed and service mode is off. To enter
programming mode, enter the “Service PIN-code” (default value is 1-1-1-1) using an external VALET
button or the VALET button located on the base unit.
!
s
ee
The
deTailed
descripTion
of
pin-
code
enTering
procedure
in
The
“conTrol over The sysTem in case of
emergency”
secTion
of
The
user
manual
.
i
f
you
don
’
T
have
The
‘s
ervice
pin-
code
’,
you
can
enTer
programming
mode
using
The
‘s
ecreT
pin-
code
’
wriTTen
on
The
owner
’
s
card
.
The system stops to execute commands when it is in programming mode. Therefore, exit programming
mode after changing settings and parameters of the system.
To exit programming mode, use one of the following methods:
• Press and hold the VALET button for more than 10 seconds;
• Turn on and then turn off the ignition when a USB cable is disconnected and the main power supply
of the system is connected;
• Disconnect the power supply (main and USB power supply).
The system will reboot programmatically (all changes will be saved) after exiting programming mode. All
ways to exit programming mode are accompanied by sound signals of the siren and light signals of the LED
indicator. The light signals indicate the number of paired control devices.
!
s
ee
The
“c
hecking
The
number
of
paired
devices
”
secTion
for
deTailed
descripTion
.
Содержание SMART MOTO V2
Страница 45: ...45 USER MANUAL...
Страница 46: ...46 PANDORA SMART MOTO V2...
