11
10
USER MANUAL
PANDORA DXL 0110L CAR SERVICE-SECURITY SYSTEM
Code immobilizer using original car controls
Code immobilizer is a function that allows disarming, disabling engine
blocking and controlling timer channels using original car controls (button,
lever or pedal). To enter immobilizer code, programmed button (lever, pedal)
should be pressed a number of times equal the first digit of the code. Pauses
between presses should not exceed 1 second. Pauses more than 1 second will
be interpreted as the start of next digit input. Immobilizer code can consist
max of 4 digits from 1 to 9.
After entering a correct immobilizer code, depending on the settings, either
the engine blocking will be lifted or a programmed timer channel will be
activated or the system will be disarmed.
Replacing immobilizer tag battery
Carefully open the cover of the
tag’s battery compartment.
Extract discharged battery
and insert a new one keeping
in mind the correct polarity.
Replacing a battery will not cause
a loss of tag code information, as
authorization data is stored in the
non-volatile memory of the MCU.
Carefully close the cover of the
tag’s battery compartment. All
elements of construction should
be rigidly locked in places. If it is
so, the tag can be operated as usually.
Control over system in case of emergency
In case you cannot disarm the system using a tag, owner’s individual PIN-
code can be used. Individual PIN-code is written on the owner’s plastic card
under protective layer. The code must be entered only when the base unit
is powered and the ignition is switched off. PIN-code should be entered
using external or located on the base unit VALET button. The digits input and
correct input is indicated by the beeper sounds.
Entering the PIN-code.
• Enter the first digit of the code using
VALET
button. Press the button
a number of times, equal to the first digit. Pauses between presses should
not exceed 1 second. Pause for more than 1 second and a short sound of the
Beeper confirm the input of the first digit. Then you can enter the next digit.
• Enter the second digit of the code using
VALET
button. Press the button
a number of times, equal to the second digit. Pauses between presses should
not exceed 1 second. Pause for more than 1 second and and a short sound of
the Beeper confirm the input of the second digit. Then you can enter the next
digit.
• Enter the third digit of the code using
VALET
button. Press the button a number of
times, equal to the third digit. Pauses between
presses should not exceed 1 second. Pause for
more than 1 second and a short sound of the
Beeper confirm the input of the third digit. Then
you can enter the next digit.
• Enter the fourth digit of the code using
VALET
button. Press the button a number of
times, equal to the fourth digit. Pauses between
presses should not exceed 1 second. The system
will confirm correct PIN-code with the series of
sound signals of the Beeper and the system will
be disarmed. If the input was incorrect, it will be
indicated with a short sound signal of Beeper
and the system will stay in previous state. New
input can be attempted after 5 seconds.
WARNING!
CAREFULLY REMOVE THE PROTECTIVE LAYER, DO NOT USE
SHARP OBJECTS TO AVOID DAMAGING OF HIDDEN INFOR-
MATION UNDER A PROTECTIVE LAYER.
Open here
2-2-2-2
PIN
«VALET»
button
