P
a
n
chromatic
Eumig P26
User Manual
4
www.Panchromatic.co.uk
INSTRUCTIONS FOR USE
The EUMIG SUPER PROJECTOR P 26 is capable of projecting pictures of
utmost sharpness and brilliance it is fitted with a first class coated and
Interchangeable lens EUPRONAR f/1.4.
EUMIG P26 is suitable both for AC and DC mains, it is provided
especially for projection lamps of 500 Wafts 110 Volts (as f.i. Philips
Type 6152 C. socket P28, with cap). The pilot lamp (e. g. perfume
evaporator lamp 13 Watts, socket E 14, frosted if possible) must be of
the some voltage as the local supply.
Before using the projector, care must be taken that the voltage shown
on the top resistance corresponds exactly to that of the local supply.
There is only one exception to this rule, i.e. the top piece for 110 Volts
which not only allows the projector to be used on a mains tension of 110
Volts with any appropriate projection lamp 110 Volts up to 500 Watts
but also on a mains tension of 220 Volts with any appropriate projection
lamp of 220 Volts up to 500 Wafts.
A resistance for the motor only is housed in the base of the machine and
a slider
28
(as per
Fig.B
) is provided, by means of which this driving
motor may be adjusted to any mains tension of 110 to 240 Volts. In
order to insert the projection lamp, just lift the top piece
4
(
Fig.B
) and fit
the lamp into the holder by pressing down and turning in a clockwise
direction. Plug
18
(
Fig.B
) serves for the connection of a table lamp, if
required; it is in contact only when switch 17 (
Fig.A
) is in the "off"
position.
MOUNTING OF SPOOL ARMS.
Open these out. engage the two projections in the slots in the body-
work of the projector and tighten up the screw
14
(
Fig.B.
) Be careful
that the pulleys of the spool arms are on the same side of the machine
as the corresponding driving pulleys, as can be seen in
Fig.B.
Now
mount the spring belts as shown in
Fig.B.
