Panasonic YD-500GP5, Руководство по эксплуатации

Страница: 12 / 64

Installation and Power supply facility
8
3 Installation and Power supply facility
When installing or transporting the welding machine, wear long sleeve shirts, leather gloves and
safety shoes to prevent injury.
3.1 Installation site
(1) Locate indoors only, where the floor is capable of supporting the weight of the product.
(2) Avoid exposure to the direct sun light or the rain or water spray.
<Note>
If exposed to the rain or water spray, or dew
condensation occurred, dry the product
before using it.
(3) Ambient temperature
(a) During cutting operation: -10 °C to 40 °C
(b) During transportation/storage: -20 °C to 55 °C
(4) Humidity relative to temperature
(a) Up to 50 % at 40 °C.
(b) Up to 90 % at 20 °C.
(5) Altitude above sea level: Up to 1 000 m.
(6) Inclination to installation surface: Max. 10 °
(7) Do not block cooling air intake of the cutting
power source
• From the wall: 200 mm or more.
(8) Avoid wind to the arc. (Provide windshields.)
(9) Free from abnormal amounts of dust, acid, corrosive gases or substances etc. other than those generated by
the cutting process.
Note:
●
In case the machine with wheels is placed on an
inclined surface, machine may slide by itself.
●
Please use stop device
●
Please do NOT turn over and lay the machine down
on the floor.
●
Up-side-down use can worsen cooling performance
of the machine and may cause the machine burnt or
overheated.
●
Please vertically place the machine on the horizontal
surface.
Please
●
When the product is installed on the floor where it is too low to operate, customers
are required to prepare a table to mount the product on.
●
Such table should be provided with flanges on the mounting surface to prevent the
product to slide off the table.
200 mm
or more
300 mm
or more