30
②
Press the Controller & PTZ menu button. Then PTZ menu screen is displayed.
Figure 3.4.4. Controller & PTZ Setup Screen
Note
: For speed dome cameras that support RS-485, connect them directly to the RS-485 port. If the
camera is controlled with RS-232C, use an RS-485 to RS-232C signal converter.
On the PTZ control setup screen, you can select or set the protocol type of the camera that is the same as
the one installed on the site. If the camera has a specific camera ID, select the camera ID using the mouse
or the control button (
◀ ▲ ▶ ▼
) of the remote control.
The following options are available on the PTZ setup screen.
CONTROLLER
(controller type)
CHANNEL
(channel number that the PTZ is connected to)
CAMERA
(camera protocol type)
SPEED
(19200, 14400, 9600, 4800, and 2400)
ID
(0-63)
3-4-4. Motion Zone Setup
Select MOTION ZONE using the mouse or the control button (
◀ ▲ ▶ ▼
) on the remote control and
select either PARTIAL ZONE or FULL ZONE using the mouse control. The default value is FULL ZONE.
If FULL ZONE is selected, the motion setting screen is not displayed. Only set the level of sensitivity for
MOTION SENSITIVITY.
FULL ZONE
: The motion sensor is active on the whole screen.
PARTIAL ZONE
: The motion sensor is active in the set detection frame.
Select the sensor detection position using the mouse or the control button (
◀ ▲ ▶ ▼
) on the remote
control. Then the color of the position which is selected will be changed. And the press the right button of
the mouse or SEL button of the remote control. Press OK button of the SETUP menu to save the setting
value.
Содержание X-Plus Series SP-DRH04
Страница 81: ...81 9 7 3 DEVICE ...
Страница 82: ...82 9 7 4 STORAGE 9 7 5 SYSTEM ...
Страница 83: ...83 9 7 6 SECURITY 9 7 7 NETWORK ...