Step 1
Remove the fixing screws (3 pcs.*) that are securing the
housing base and the camera.
The removed screws will be required when attaching the
housing base to the camera again. Use caution not to lose
these screws.
* Special screw (Fixing screw): These screws are hexagon
screws. Use an M5 hexagon wrench.
Housing base
Camera
Protection Cover
Fixing screws (3 pcs.)
Note:
• If the front and rear sunshields (accessory) are
attached to the camera, detach them by performing
steps 5 - 7 of "Installation" in the reverse order.
(
☞
Page 22)
Protection Cover
Important:
• Remove the Protection Cover from the camera after
the installation is complete.
SW396A
SW395A
Step 2
To separate the housing base from the camera, turn the
housing base to the direction of the arrow as illustrated.
(Refer to the illustration in Step 1)
Step 3
Remove the attachment pipe from the upper base by
loosening 4 screws.
REAR
x 4
How to detach the housing base
SW396A
SW395A
SW396A
SW395A
19
