![background image](http://html.mh-extra.com/html/panasonic/wv-sw115/wv-sw115_installation-manual_1511946013.webp)
13
Precautions for installation
This product is designed to be installed
under eaves.
Install the product under eaves to avoid direct
sunlight.
Installing place
Contact your dealer for assistance if you are
unsure of an appropriate place in your partic-
ular environment.
• Make sure that the installation area is
strong enough to hold this product, such
as a concrete wall.
• When this product and camera mount
bracket are mounted on a wall, use the
screws described in page 19. The screws
that secure the product are not supplied.
Prepare them according to the material
and strength of the area where the product
is to be installed.
• Do not mount the product on a plaster
board or a wooden section because they
are too weak. If the product is unavoidably
mounted on such a section, the section
shall be sufficiently reinforced.
Do not place this product in the following
places:
• Locations where a chemical agent is used
such as a swimming pool
• Locations subject to humidity, dust, steam
and oil smoke
• Locations where a radiation, an X-ray, a
strong radio wave or a strong magnetic
field is generated
• Locations where corrosive gas is pro
-
duced, locations where it may be damaged
by briny air such as seashores
• Locations where the temperature is not
within the specified range (page 31)
•
Locations subject to vibrations that exceed
the railway specifications (EN50155)
• Locations subject to condensation as the
result of severe changes in temperature (In
case of installing the product in such loca-
tions, the dome cover may become foggy or
condensation may be caused on the cover.)
Be sure to remove this product if it is not
in use.
Design and engineer the power supply
system to turn on/off the power of this
product.
The product has no power switch. When
installing the product, use a PoE hub equipped
with the ON-OFF switch for servicing.
Protection from lightning
When cables are used outdoors, there is a
chance that they may be affected by lightning. In
this case, install a lightning arrester just before
where the cables connect to the camera.
Screw tightening
• The screws must be tightened with an
appropriate tightening torque according to
the material and strength of the installation
area.
• Do not use an impact driver. Use of an
impact driver may damage the screws.
•
When a screw is tightened, make the
screw at a right angle to the surface. After
tightening the screws or bolts, perform
visual check to ensure tightening is enough
and there is no backlash.
Procure fixing screws separately.
The screws that secure this product are not
supplied. Prepare them according to the mate-
rial and strength of the area where the product
is to be installed.
Panasonic assumes no responsibility for injuries or property damage resulting from fail-
ures arising out of improper installation or operation inconsistent with this documenta-
tion.
Содержание WV-SW115
Страница 35: ...35 ...