13
Precautions for installation
In order to prevent injury, the product
must be securely mounted to a wall or
ceiling according to Installation Guide.
Power supply
This product has no power switch.
When turning off the power, disconnect the
power supply from the PoE device.
Installation area for this product
Select an appropriate place for the installation
area (such as a strong wall or ceiling) in your
particular environment.
• Make sure that the installation area is
strong enough to hold this product, such
as a concrete ceiling.
• Install the camera in the foundation area of
the architecture or where sufficient strength
is assured.
• Do not mount the product on a plaster
board or a wooden section because they
are too weak. If the product is unavoidably
mounted on such a section, the section
shall be sufficiently reinforced.
This camera is designed to be used
indoors.
This product is not operable outdoors.
Do not expose this camera to direct sunlight
for hours and do not install the product near a
heater or an air conditioner. Otherwise, it may
cause deformation, discoloration and malfunc-
tion. Keep this camera away from water and
moisture.
Do not place this product in the following
places:
• Locations where a chemical agent is used
such as a swimming pool
• Locations subject to moisture or oil smoke
such as a kitchen
• Locations that have a specific environment
that is subject to an inflammable atmo-
sphere or solvents
• Locations where a radiation, an X-ray, a
strong radio wave or a strong magnetic
field is generated
• Locations near coasts directly subjected to
sea breezes, or locations subject to corro-
sive gases such as from hot springs, vol-
canic regions, etc.
• Locations where the temperature is not
within the specified range (
☞
page 28)
• Locations subject to vibrations, such as on
vehicles, marine vessels, or above product
lines (This product is not designed for on-
vehicle use.)
• Locations where it may get wet from rain
or water splash (including under the eaves,
etc.)
• Locations subject to moisture or dust
• Locations subject to condensation as the
result of severe changes in temperature (In
case of installing the product in such loca-
tions, the dome cover may become foggy
or condensation may be caused on the
cover.)
Sulfurization caused by rubber products
Do not place the product near rubber products
(packing, rubber feet, etc.) that contain sulfur.
There is a risk that sulfur components in rubber
products may cause electrical parts and termi-
nals, etc. to become sulfurized and corrode.
Check before installation
Compatibility of devices is restricted. Before
installation, check the ratings and dimensions
of the devices to be used.
Contact your dealer for details.
Protection from lightning
When connecting to a network using the network
cable of this product, observe the following.
• When wiring for the network, design and
engineer not to be affected by lightning.
Panasonic assumes no responsibility for injuries or property damage resulting from
failures arising out of improper installation or operation inconsistent with this
documentation.
