![background image](http://html.mh-extra.com/html/panasonic/wv-sc380-series/wv-sc380-series_operating-instructions-manual_277968138.webp)
* If Patrol 1 is not registered it is not displayed on the screen.
•
Preset per sender
SW396
SW396
SC386
SC386
:
By registering the sender's address for the command alarm and
the preset position for that address, the camera will move to the preset position when an alarm is detected
from the command alarm.
Click “Preset per sender >>” to open a separate window for setting preset positions for alarms.
(
®
•
Default:
Off
13.2.1 Configure the settings relating to Preset per sender (“Preset
per sender” setup menu) (SW396/SC386)
On the [Alarm] tab (
®
page 136), click “Preset per sender >>” for “Command alarm”.
The sender's address for the command alarm, and the preset position for that address can be registered in
this section.
[Sender’s address 1] - [Sender’s address 8]
Set the sender's IP address for the command alarm, and the preset position for that address. Up to 8 notification
addresses can be set.
•
[Auto track cooperation] checkbox:
When the checkbox is selected, auto tracking starts after the
direction of the camera moves to the preset position.
[Close] button
Click this button to close the “Preset per sender” setup menu.
13.3 Configure the settings relating to the alarm
image [Alarm]
Click the [Alarm] tab on the “Alarm” page. (
The settings relating to the alarm image to be transmitted to an FTP server can be configured in this section.
The alarm image will be transmitted to an FTP server. To transmit alarm images to an FTP server, it is
necessary to configure the settings in advance. (
®
IMPORTANT
•
Depending on the network line speed or the network traffic, images may not be transmitted at the exact
designated interval or period.
138
Operating Instructions
13 Configure the alarm settings [Alarm]