18
②
12 V DC power supply terminal
Connect the output cable of the DC power supply to the power cable plug (accessory).
③
Audio input connector
Connect an external speaker* using a ø3.5 mm stereo mini plug (monaural output
S6131
S6111
/
stereo output
S6130
).
• Output impedance
: Approx. 600 Ω (unbalanced)
• Recommended cable length
: Less than 10 m {32.8 feet}
• Output level
: –20 dBV
* Use a powered speaker.
④
Audio output connector
Caution:
• A READILY ACCESSIBLE DISCONNECT DEVICE SHALL BE INCORPORATED TO THE
EQUIPMENT POWERED BY 12 V DC POWER SUPPLY.
• ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY (UL 1310/CSA 223) or LIMITED
POWER SOURCE (IEC/EN/UL/CSA 60950-1).
IMPORTANT:
• Be sure to use the power cable plug (accessory) provided with this product.
• Be sure to fully insert the power cable plug (accessory) into the 12 V DC power supply
terminal. Otherwise, it may damage the camera or cause malfunction.
• When installing the camera, make sure that excessive force is not applied to the power cable.
• Be sure to use an AC adaptor compliant with the specifications (written in the indication label
on the bottom side of this unit) regarding power source and power consumption.
Connect a microphone or the line out of an external device using a ø3.5 mm stereo mini plug
(monaural input
S6131
S6111
/ stereo input
S6130
).
• Input impedance
: Approx. 2 kΩ (unbalanced)
• Recommended cable length
: Less than 1 m {3.28 feet} (for microphone input)
Less than 10 m {32.8 feet} (for line input)
• Recommended microphone
: Plug-in power type (locally procured)
(Sensitivity of microphone
: –48 dB ±3 dB (0 dB=1 V/Pa,1 kHz))
• Supply voltage
: 4.0 V±0.5 V
S6131
S6111
2.5 V±0.5 V
S6130
• Input level for the line input
: Approx. –10 dBV
IMPORTANT:
• Connect/disconnect the audio cables and turn on the power of the camera after turning off
the power of the audio output devices. Otherwise, loud noise may be heard from the speaker.
• Make sure that the stereo mini plug is connected to this cable. When a monaural mini plug is
connected, audio may not be heard.
When connecting a monaural speaker with amplifier, use a locally procured conversion cable
(mono-stereo).
Note:
S6131
S6111
• The audio output can be switched to the monitor output. Refer to the "Operating Instructions"
on the provided CD-ROM for descriptions of how to switch the output.
• The monitor out is set to NTSC in the default settings of the camera. If you want to change the
monitor out setting to PAL, refer to the Operating Instructions on the provided CD-ROM.
