23
①
INITIAL SET button (Initializing button)
Follow the steps below to initialize the network camera.
⑴
Turn off the power of the camera. When using a PoE hub, disconnect the Ethernet cable from
the camera. When using an external power supply, disconnect the power cable plug (accessory)
from the 12 V DC power supply terminal.
⑵
Turn on the power of the camera while pressing the INITIAL SET button, and make sure to
release the button after approximately 15 seconds. In about 2 minutes later, the camera will start
up and the settings including the network settings will be initialized. Retry if the camera does not
start up normally.
IMPORTANT:
• When the camera is initialized, the settings including the network settings will be initialized.
Before initializing the settings, it is recommended to write down the settings in advance.
• Do not turn off the power of the camera during the process of initialization. Otherwise, it may
fail to initialize and may cause malfunction.
②
SD MOUNT indicator
SD memory card status
SD MOUNT indicator status
When an SD memory card is inserted and could be
recognized
Lights off
→
Blinks green
→
Lights off
When an unformatted SD memory card is inserted and
formatted on the setup menu
Lights off (When inserted/formatting)
→
Blinks green
→
Lights green
When the SD memory card in use is formatted on the
setup menu
Lights green
→
Lights off (Formatting)
→
Blinks green
→
Lights green
When data can be saved after the SD memory card is
inserted and the SD ON/OFF button is pressed (less than
1 second)
Lights off
→
Lights green
When data can be saved to the SD memory card
Lights green
When the SD memory card is removed
after holding down the SD ON/OFF button
(about 2 seconds)
(recording)
Lights green
→
Blinks green
→
Lights off
(waiting for
recording)
Lights green
→
Lights off
When data cannot be saved to the SD memory card
because an abnormality was detected or the SD memory
card is configured not to be used
Lights off
