14
Before starting installation
Available system configuration is limited. Start installa-
tion after confirming ratings and dimensions. Contact
your dealer for further information.
About mini SD memory card
• Before inserting a mini SD memory card into the
mini SD memory card slot, turn the power of this
product off. Otherwise, it may cause malfunction or
damage data recorded on the mini SD memory
card. Refer to pages 22 and 23 for descriptions of
how to insert/remove a mini SD memory card.
• When using unformatted mini SD memory card, for-
mat it using this product. Recorded data on the
mini SD memory card will be deleted when format-
ted. If using an unformatted mini SD memory card
or using a mini SD memory card formatted with
other device, this product may not work properly or
performance deterioration may be caused. Refer to
the setup instructions (PDF) for how to format a
mini SD memory card.
• It is recommended to use Panasonic’s mini SD
memory cards (
☞
page 6) since they have tested
and confirmed full compatibility with this product. If
another mini SD memory card is used, this product
may not work properly or performance deterioration
may be caused.
Router
When connecting this product to the Internet, use a
broadband router with the port forwarding function
(NAT, IP masquerade).
Refer to the setup instructions (PDF) for how further
information about the port forwarding function.
Heater unit
When the heater unit is installed and use is started in
environments of –10°C {14°F} or below, normal images
may not be obtained immediately after the camera is
started up. In this case, wait for the camera to warm up
(about 2 hours or more) before turning the power on
again.
• 24 V AC Power Supply Connection for WV-NW964
Accessory Connector Information
How to Assemble the Cable with the Accessory
Connector for WV-NW964
Strip back the cable jacket approx. 3 mm {0.1"} and
separate the individual conductors.
Prepare the individual conductors for clamping. Use
MOLEX band tool part number 57027-5000 (for UL-
Style Cable UL1015) or 57026-5000 (for UL-Style
UL1007) for clamping the contacts.
After clamping the contacts, push them into the proper
holes in the accessory connector of this camera until
they snap in place.
Cautions:
• Shrinking the cable-entry seal is a one-time proce-
dure. Do not shrink the cable-entry seal until ascer-
taining that the unit is functioning.
• CONNECT THIS TO 24 V AC CLASS 2 POWER
SUPPLY ONLY.
Contact
Insert
Up
A
Approx.
3 mm {0.1"}
Insert the wire until A position
and clamp the contacts.
Wire
Contact
Up
Wire
Recommended wire gauge sizes for 24 V AC line
#24
(0.22mm
2
)
Copper wire size
(AWG)
Length
of cable
(approx.)
(m)
(ft)
#22
(0.33mm
2
)
#20
(0.52mm
2
)
#18
(0.83mm
2
)
20
30
45
75
65
100
160
260
1
3
2
4
Pin no.
Power source
1
2
3
4
24 V AC LIVE
24 V AC NEUTRAL
Ground
Not use
