18
Installation
Connect the safety wire
The following is an example of safety wire connection. A safety wire kit shall be procured in accor-
dance with the mounting face of the camera.
Refer also to the instructions for the safety wire kit at mounting the safety wire.
Important:
• Be sure to install the safety wire. Ask your dealer for installation.
For mounting on ceiling
<Required camera mount bracket and safety wire
kit>
• Camera mounting plate: WV-7010A
• Safety wire kit: WV-Q141
z
Remove the tripod mount base on the top of
the camera.
x
Align the tripod mount base with the safety wire
plate for ceiling (accessory) and attach them to
the camera with the mounting screws.
Important:
• Use the detached mounting screws to attach the tripod mount base. When using different
length screws, it may damage the camera or cause the camera to fall.
(Recommended tightening torque: 0.39 N·m)
c
Engage the safety wires (2 pieces) with the wire engaging holes (front and rear) respectively.
Wire engaging hole
Connection hook
Safety wire
T
Mounting screws
Exhaust port
Tripod mount
base
Safety wire plate
for ceiling
(accessory)
Wire engaging
hole (front)
Wire engaging
hole (rear)
q
Pass the ring part of the safety wire
through the wire engaging hole.
w
Pass the connection hook through the ring
part of the safety wire.
Important:
• Use caution to prevent the safety wire from entering into the exhaust port.
