![background image](http://html.mh-extra.com/html/panasonic/wv-cz392e-wv-cz492e/wv-cz392e-wv-cz492e_operating-instructions-manual_277903026.webp)
26
BURST (BW) Setting
Move the cursor to select "ON" or "OFF".
ON:
The burst signal is supplied along with
the black-and-white composite video.
OFF:
The burst signal is not output.
Default setting: ON
Note:
•
With some monitors and VTR models, output of a
camera images in the black-and-white mode will
not display a proper image unless a burst signal
is provided. Select "ON" for this setting when
using equipment that requires a burst signal.
9
Auto Focus Setting
STOP AF:
The AF mode activates during
or after lens operation.
AUTO:
The AF mode activates when the
illuminance is changed.
Default setting: STOP AF
Note:
•
Long use in "AUTO" mode may shorten
the service life of the lens drive.
•
Auto-focus may not be possible with the
types of objects listed below. For such
objects, focus manually.
1.Dirt or water on window glass.
2.Low lighting or illumination.
3.Bright objects or high intensity objects.
4. Single color object such as a white wall
or fine felt.
5.sloping objects.
Auto-focus focuses on the object in the center
of the picture, so objects around the outside
periphery of the picture will not be in focus.
!
Motion Detector Setting
1. Select "OFF", "MOTION DET" or "SCENE CHANGE".
OFF:
Turns off the motion detector.
MOTION DET:
Alarm signal is output when
motion is detected in the
image. Selecting "MOTION
DET" and pressing the
[SET] button displays the
"MOTION DET" menu, which
can be used for configuring
detailed settings.
SCENE CHANGE:
Alarm signal is output
when the camera is
covered by cloth, a lid,
spray paint or something.
Default setting: OFF
VMD
The motion detector divides the screen
into 48 blocks and monitors changes in the
luminance in each block. When it detects
any change (movement) in the image, it
outputs an alarm signal. When a change
(movement) in the image is detected
while in the auto mode, the alarm signal is
output and the camera stops at the preset
position for a specified amount of time.
Important:
Conditions for SCENE CHANGE
Monitoring might not be possible in the
following situations.
•
If only one part of the screen is not
covered, or if the covering is translucent.
Also, false detection might occur in the
following situations.
•
When extreme changes in lighting
occur, such as turning lights on an off.
•
If pedestrian or vehicle traffic is heavy.
Note:
•
If you want to set a motion detector for
each preset position, do the scene file
setting. (refer to page 31)
2. Select "MOTION DET" and press the [SET]
button, "MOTION DET" menu appears.
Mask setting can be set in this menu.
3. Move the cursor to "MASK SET " and
press the [SET] button, 48 mask areas
appears on the monitor screen.
For more information, refer to Light
Control Setting on page 22.
LEVEL ···I···131
DWELL TIME 2S
DISPLAY MODE
MASK SET
RECOVER TIME OFF
RET TOP
ALARM OFF
**MOTION DET**