![background image](http://html.mh-extra.com/html/panasonic/wv-cz392e-wv-cz492e/wv-cz392e-wv-cz492e_operating-instructions-manual_277903025.webp)
25
•
If white balance adjustment cannot be
completed for some reason, "PUSH SET"
will remain highlighted on the display. If
this happens, it could mean that the color
temperature is outside the supported
range, or that illumination is too low.
(3) For fine adjustment of the "AWC" press
the [RIGHT] button, select "AWC ".
The AWC fine adjustment menu appears
on the monitor screen.
7
Digital Noise Reduction
DNR may be used to improve quality
under low light conditions.
There are 2 levels of DNR, which may be
selected depending on local site conditions.
LOW:
Low DNR, Low afterimage.
HIGH:
High DNR, High afterimage.
Default setting: LOW
8
Black-and-white Mode Setting
You can set up the BW mode on this menu.
BW Setting
1. Move the cursor to "BW" and select "EXT",
"AUTO", "ON" or "OFF".
EXT:
Changes between the color and
black-and-white mode according to
the D/N IN terminal.
AUTO:
The camera selects the black-and-white
mode if the picture is dark, or the color
mode if the picture is bright enough.
ON:
The black-and-white mode is selected.
OFF:
The color mode is selected.
Default setting: OFF
Note:
•
When "AUTO" is selected, it is recommended
to set "AGC" to "ON" before use.
•
At the time of "EXT" setup, the controller
cannot be used for ON/OFF control.
2. When "AUTO" is selected, it becomes possible
to set up the LEVEL and DURATION TIME.
3. When "AUTO" is selected, move the cursor
to "LEVEL" and press the [LEFT] and
[RIGHT] buttons to set the illuminance when
switching to black-and-white or color mode.
The illuminance shown below is based on
the assumption that the camera is used in
an area lit by halogen lamps.
LOW:
Switches to the black-and-white
mode when illuminance around the
camera is approximately 1.5 lx or
lower (when AGC ON (MID), SENS
UP OFF is set).
HIGH:
Switches to the black-and-white
mode when illuminance around
the camera is approximately 3 lx or
lower (when AGC ON (MID), SENS
UP OFF is set).
Default setting: HIGH
Note:
•
When near-infrared lamps are used, the
image may be displayed out of focus
and mode switching may not perform
automatically.
4. Move the cursor to "DURATION TIME".
The camera determines whether to switch the
mode when the time set for holding a picture
motionless on the screen has elapsed.
Available duration times:
(S) 2 s
10 s
30 s
60 s (L)
Default setting: 10 s
RET TOP
**AWC**
R ···I··· 0
B ···I··· 0
RET TOP
BW OFF
BURST(BW) ON
**BW MODE**
RET TOP
BW AUTO
LEVEL HIGH
BURST(BW) ON
DURATION TIME ·I··
S L
**BW MODE**