![background image](http://html.mh-extra.com/html/panasonic/wv-cz352/wv-cz352_operating-instructions-manual_277901020.webp)
20
●
Alarm signal will take approx. 0.2 seconds to reach the alarm terminal of the VTR
after the camera detects the object.
Because the alarm signal is multiplexed on the video signal, it may be mistakenly
interpreted by other video equipment as a time code signal. Therefore, when this
camera is not used in a Panasonic Intelligent CCTV System, select OFF to prevent
the above from occurring.
9
Digital Noise Reduction Setting (DNR)
DNR may be used to improve quality under low light conditions.
There are 4 levels of DNR, which may be selected depending on local site conditions.
LOW1:
DNR level is low. The after-image remains.
LOW2:
DNR level is low. The after-image is reduced.
HIGH1:
DNR level is high. The after-image remains.
HIGH2:
DNR level is high. The after-image is reduced.
0
Resolution Setting (RESLOUTION)
Move the cursor to RESOLUTION and select NORMAL or HIGH.
-
Black and White Mode Setting (BW MODE)
You can set up the BW mode on this menu.
BW Setting
1. Move the cursor to BW and select EXT, AUTO, ON or OFF.
EXT:
Changes between the colour and B/W mode according to the D/N IN terminal.
AUTO:
The camera selects the black and white mode if the picture is dark, or the colour
mode if the picture is bright enough.
ON:
The black and white mode is selected.
OFF:
The colour mode is selected.
Note:
At the time of EXT setup, the controller cannot be used for ON/OFF control.
2. When AUTO is selected, it becomes possible to set up the LEVEL DURATION
TIME.
3. Select HIGH or LOW for the threshold level at which the camera automatically
switches to BW or colour mode.
The illuminance shown below is based on the assumption that the camera is used in an
area lit by halogen lamps, and that AGC on the menu is set to MID.
** BW MODE **
BW OFF
PIX SENS UP OFF
BURST(BW) OFF
RET TOP END
Содержание WV-CZ352
Страница 31: ...31 ...