![background image](http://html.mh-extra.com/html/panasonic/wv-clr920a/wv-clr920a_operating-instructions-manual_277789046.webp)
-46-
To reset to the factory settings
1. Move the cursor to CAMERA RESET. PUSH SW is
highlighted.
2. While holding down
L
and
M
, press
I
for 2
seconds or more. The camera is reset to the factory
settings.
** SPECIAL **
UP SIDE DOWN OFF
CHROMA GAIN ....I....
AP GAIN ....I....
PEDESTAL ....I....
- +
BW OFF
BURST (BW) ON
CAMERA RESET PUSH SW
RET END
5. Move the cursor to LEVEL and select the illumi-
nance level using
L
or
M
.
LOW:
Colour picture switches to black-and-white at
approximately the minimum illumination.
HIGH:
Colour picture switches to black-and-white
at a point brighter than the minimum illumina-
tion.
The factory default setting is HIGH.
6. Move the cursor to DURATION TIME to set the
switching time using
L
or
M
.
The following switching times are available:
10s--30s--60s--300s
(S)
(L)
10-6. BURST (BW)
1. Move the cursor to BURST (BW).
2. Select ON or OFF using
L
or
M
.
Default: ON
ON:
The burst signal is supplied along with the
black and white composite video signal.
OFF:
The burst signal is not output.
Note:
Select the appropriate mode for the con-
nected recording device and monitor TV
when setting BW (10-5) and burst signal
(10-6). There may be cases where the
selection will adversely affect synchro-
nization. Select the mode after confirming
that the live picture and playback picture
are properly displayed on the monitor.