2-2
8
Referring to Fig. 2-3, remove two screws and three washers
that secure the Main Unit, and remove the Main Unit from
the Camera Unit.
Fig. 2-3
8
Referring to Fig. 2-4, remove two screws that secure the
Camera Bottom Case and remove the Camera Bottom
Case from the Main Unit.
8
Disconnect the Connector CN3 on the Main Board and
remove the Wire Ass'y.
Fig. 2-4
Fig. 2-6
8
Referring to Fig. 2-5, remove two screws that secure the
Main Board, disconnect the Connector CN1 on the Main
Board and remove the Main Board from the Main Unit with
the Sensor Board in order to service the Main Board.
8
Remove two screws that secure the Sensor Board and
remove the Sensor Board from the Main Unit in order to
replace the Optical Ass'y (IC1) or service the Sensor Board.
Fig. 2-5
8
Reconnect the connectors by using Extension Cable Ass'y
between CN1 on the Sensor Board and CN1 on the Main
Board as follows in order to service.
8
Referring to Fig. 2-6, connect the Connector CN1 on the
Extension Cable Ass'y to CN1 on the Sensor Board.
8
Connect the Connector CN3 on the Extension Cable Ass'y
to CN1 on the Main Board.
Sensor Board
CN1
Main Unit
Main Board
CN1
Remove two screws.
Optical Ass'y (IC1)
Remove two screws.
Camera Bottom Case
Wire Ass'y
Remove two screws.
Main Unit
CN3
CN1
CN1
CN1
CN3
Main Board
Sensor Board
Main Board
Extension Cable Ass'y
(Camera Unit)
Remove two screws.
Main Unit
Camera Unit
Washers
Washer
