45
Inst
allation
7
Attach the scanner to the unit.
1) Take the scanner out.
2) Align the shaft of the scanner with the slot of
the slider and push the shaft in the direction of
the arrow
1
shown in the figure allowing the
narrow part of the shaft to fit in the slot. Fit the
shaft in the slot and return the shaft to the
original position
2
until it is locked into place.
3) Connect both cables to the corresponding
connectors. Secure both cables using the
clamper.
4) Attach the connector cover with the black
resin inside the cover.
8
Connect the power cord.
Securely fit the supplied power cord in the AC
inlet of the control box.
9
Wipe the whiteboard surfaces.
Soak a soft cloth with water, wring well, and
wipe the whiteboard surfaces.
10
Remove the battery protection
sheet.
11
Check operations.
Refer to “Electronic Board Operations Check”
on page 46.
1
1
2
2
Shaft
Scanner
Slot
Slider
Cables
Clamper
Connectors
Connector Cover
Black Resin
AC inlet
Power cord
