40
Channel Name:
Indicates the correlation between the
camera title and serial number. Channel name can
be changed using the provided software.
Cautions:
For the [All] operation and functions, refer to the
timer recording explanation.
Notes:
1. "CH Enable" of channel 1 cannot be set at "Off". During
playback in channel 1, it is impossible to set up its
masking area.
Mask Enable:
"On":
Used to enable masking area setup. The masked
area will not be displayed and recorded (Black
screen will be recorded.).
"Off":
The masking function is not effective.
2. During operation in sequence mode, "CH Enable" can-
not be set up.
3. When the setup value for "Rec. Reserve" exceeds one
day, the screen data for a maximum of "preset number
of days + 4 hours" can be reserved.
4. "Mask Area" can be set up with the procedures speci-
fied below.
Move the cursor to "Set" of "Mask Area" and press the
[SET] button. The masking area setup screen is then
opened.
a) The red cursor in the above diagram indicates the
starting position and the black cursor indicates the
ending position. When the direction button is used,
it is possible to move both the red and black cur-
sors simultaneously throughout the area. It is also
possible to move the black cursor only to adjust the
area size. Determine if you make a control mode
changeover by pressing the [SET] button, moving
the red and black cursors at the same time, or mov-
ing the black cursor only.
b) When Numeral 1 is pressed, the profile of the mask-
ing area is displayed. When 2 is pressed, all the
area is embedded.
3.1.6 Communication setup (COMMUNICA-
TION SETUP)
Network setup (NETWORK SETUP)
Move the cursor to "COMMUNICATION SETUP" on "WJ-
RT208 SETUP MENU" and press the [SET] button.
Move the cursor to "NETWORK SETUP" and press the [SET]
button.
IP Address:
IP address given to this unit
Subnet Mask:
Subnet mask for this unit
Gateway:
Gateway address for this unit
Server Port:
Port number of this unit
Protocol:
Communication protocol
Alarm Center IP:
IP address of the PC on which the
Alarm Center is installed
Alarm Port:
Communication port number of the alarm
center, 1024 - 9999
Default: [4000]
Alarm Enable:
"On" or "Off"
Default: "Off"
Line Speed:
Communication speed of the network card
is set up to match network communications.
Notes:
1. In regard to initial setting and setup enabled range,
refer to "Parameters and initial setup values for the
setup menu."
2. It is necessary to restart the unit after changing the set-
tings.
Mask area
Start position
End position
COMMUNICATION SETUP
NETWORK SETUP
RS485 SETUP
DATA PORT SETUP
OK
NETWORK SETUP
192.168.000.088
IP Address
Cancel
255.255.255.000
Subnet Mask
192.168.000.088
Gateway
2000
Server Port
TCP
Protocol
192.168.000.188
Alarm Center IP
4000
Alarm Port
Off
Alarm Enable
Auto Mode
Line Speed
Содержание WJRT208 - Digital Disk Recorder
Страница 61: ...61 ...
