Panasonic WJHD200 - Digital Disk Recorder, Руководство по эксплуатации

Страница: 88 / 94

88
You can implement any of the following operations as necessary.
REMOVE LINK: Logically removes the HDD link.
HDD FORMAT: Formats the HDD.
RESTART: Closes the menu, and restarts the recorder.
The menu can also be displayed manually when you need to format the HDD or remove the logical link.
1. Turn off the power of the recorder once, and turn it on again.
The multiscreen monitor displays the message "SYSTEM CHECK DONE! TO OPEN DISK MENU, PUSH STOP KEY".
2. Press the [STOP] button.
The DISK MENU opens.
3. Select REMOVE LINK, HDD FORMAT, or RESTART.
Auto-remove
When no button is pressed for 5 minutes after opening the DISK MENU, the recorder will logically remove a disk that meets
any of the conditions below.
• An HDD has been categorized as " * ", "LOST", or "ERR".
• Restart was repeated 3 times due to writing error.
●
DISK MENU
8 Disk Menu
The menu appears if the hard disk error is found during
power-up.
The buzzer beeps every 5 seconds, and the ERROR
indicator turns off.
Press any button other than [STOP] to mute the buzzer
beep.
The hard disk status and required operations are shown in the table.
DISK MENU
NO.1:117.95GB
NO.2:117.95GB
REMOVE LINK
→
SET
→
HDD FORMAT
→
SET
→
RESTART
→
SET
→
Hard Disk Status
Operation
Abbreviation Status Required
–
Format, remove link ,or replace HDD
if erred even after formatting.
Note
WR1 or WR2 appears in SYSTEM LOG
when indicating a writing error.
Normal status
Writing error
Same as above. LOST or * status was left for
five minutes.
All existing HDD have been previously
used in another WJ-HD200.
Restart or Format Awaiting format
HDD is removed without executing
REMOVE LINK command. Remove link, or add a new HDD. HDD physically removed
Format HDD added, and awaiting
format
Capacity
ERR
*
LOST
ADD
REMOVE LINK command has been
previously carried out. Previous time and this time,
HDD physically or logically
removed –