44
■
Set the IP address
The available setting items are the same as described in the "Check the IP address" section on the page 43.
Shift the display and configure each setting as described below. To change the port number (PT#), press the arrow button (up or
down) while the underscore mark (_) is displayed below the ">" indication.
Each port will be displayed as follows: PT#1 for camera port, PT#2 for client PC port, and PT#3 for maintenance port.
To change the port number (PT#), press the arrow button (left or right).
The settings of "Gateway" and "HTTP port" can be configured when the "PT#2" indication (client PC port) is being displayed.
The display on the LCD will shift by pressing the arrow button (up or down).
Important:
• The network settings for each port (IP address, etc.) should be configured with a different subnet. Otherwise, network communi-
cation may fail.
●
How to configure the settings for each item
1
The underscore mark will move below the number by
pressing the [SET] button while the underscore mark
is displayed below the ">" indication.
• When pressing the arrows button (left or right) while the
underscore mark is displayed below the ">" indication, the
display will be shifted to the display of the client PC port
(PT#2) or of the maintenance port (PT#3)
2
Move the underscore mark using the arrow button
(left or right), and then enter values using the arrows
button (up or down).
3
To determine the edited setting, move the under-
score mark below the ">" indication by pressing the
[ESC] button.
■
Enable/disable the key lock
It is possible to lock the buttons on the front panel to make them unusable. When the [SET] button is pressed while displaying the key
lock display, the message of "Keylock Enabled" will be displayed and the buttons on the front panel will be locked. The time and date
display (standby display) will be displayed soon after the buttons are locked.
To disable the key lock, enter the password (default: 12345) on the password entry display. The password can be changed on the
setup menu.
Refer to the setup instructions (PDF) for further information.
[SET]
[SET]
[ESC]
