Installation of Network Adaptor and Base Pan Heater
Network Adaptor and Installation (Optional)
1.
Open the Cabinet front plate and Cabinet top
plate,
then connect the Network Adaptor Cable
to the CN-CNT
connector on the printed circuit
board.
o
Pull the cable out of the Mono bloc unit so that
there is no pinching.
o
If an optional PCB has been install in the
Mono bloc unit, connect the CN-CNT
connector to Optional PCB.
2.
Insert a flat head screwdriver into the slot on
the top of the
adaptor and remove the cover.
Connect the other end of the
CN-CNT cable
connector to the connector inside the adaptor.
3.
On the wall near the Mono bloc
unit, attach the
adaptor by
screwing screws through the
holes
in the back cover.
4.
Pull the CN-CNT cable through
the hole in the
bottom of the
adaptor and re-attach the front
cover to the back cover.
5.
Use the included cord clamp to fix the CN-CNT
cable to the
wall.
Pull the cable around as shown in the diagram so
that external forces cannot act on the connector in
the adaptor.
Base Pan Heater (Optional)
It is strongly recommended to install a Base Pan Heater (optional) if the Mono bloc unit is installed in cold climate
area. Refer the Base Pan Heater (optional) installation instruction for details of installation.
Network Adaptor
cable
Network Adaptor cable
Without Optional PCB
With Optional PCB
Slot
Connector
Screws
CN-CNT cable
(Take care not to
pinch the cable)
Cord clamp
