114
How to connect wiring to the terminal
For stranded wiring
(1) Cut the wire end with cutting pliers, then strip the
insulation to expose the stranded wiring about
10 mm and tightly twist the wire ends.
Stranded wire
Ring
pressure
terminal
S
tr
ip
10
m
m
(2) Using a Phillips head screwdriver, remove the
terminal screw(s) on the terminal board.
(3) Using a ring connector fastener or pliers, securely
clamp each stripped wire end with a ring pressure
terminal.
(4) Place the ring pressure terminal, and replace and
tighten the removed terminal screw using a
screwdriver.
Screw and
Special washer
Ring
pressure
terminal
Terminal board
Ring pressure
terminal
Screw
Special
washer
Wire
Wire
Examples of shield wires
(1) Remove cable coat not to scratch braided shield.
(2) Unbraid the braided shield carefully and twist the
unbraided shield wires tightly together. Insulate
the shield wires by covering them with an
insulation tube or wrapping insulating tape around
them.
Insulating tape Shield mesh
(3) Remove coat of signal wire.
8 mm
Insulating tape Shield mesh
(4) Attach ring pressure terminals to the signal wires
and the shield wires insulated in Step (2).
