OPERATION
ACTUAL
HEATER
BOOSTER
QUIET
SETTING
STATUS
SERVICE
AUTO
HEAT
COOL
TANK
HEATER
FORCE
°C
°C
ON
OFF
MON TUE WED THU FRI SAT SUN
hr
hr
kwh
4. Operating Instructions of System
REMOTE CONTROL PREPARATION
Press to turn unit on or off
· When unit is ON, operation LED is lit and the actual temperature for
water outlet and outdoor ambient are shown on the remote control
display.
To select operation mode
HEAT MODE
· To turn ON or OFF the heating operation.
· In this mode the heat pump will provide energy only for the Heating
of the property.
HEAT + TANK MODE
· In this mode the heat pump will provide energy to the DHW cylinder
or the Heating or the property. (actual mode of operation will not be
indicated, and only if DHW cylinder is connected to the heat pump
control)
· This operation is not used when the DHW water tank is not
installed.
TANK MODE
· To turn ON or OFF the DHW tank operation.
· In this mode the heat pump will provide energy only to the DHW
cylinder) only if the cylinder is connected to the heat pump control).
COOL + TANK MODE
(*1, *2)
· Heat pump provides cooling to the property
· The heat pump controls the booster heater in the DHW cylinder
(only if DHW cylinder is connected to the heat pump control)
COOL MODE
(*1, *2)
· The panel is either turned ON or OFF.
· To turn ON or OFF the heat pump cooling operation
To enjoy quiet environment
· This operation reduces heat pump unit noise. In this condition, it
may cause decrease in heating capacity.
To enable the backup heater
· The backup heater will only operate when the setting conditions are
fulfi lled.
· To disabled the Heater operation manually, press the respective
button again.
REMOTE CONTROL PREPARATION
Setting Current Day and Time
Press the CLOCK button
Press the UP or DOWN button to set the current weekday
Press the SET button to confi rm the setting
Repeat steps 2 and 3 to enter the current time
*Note
The current weekday and time must be set when:
· The power supply is switched on for the fi rst time,
· After a long interruption to the power supply.
The current time set is the time basis for all timer functions
· In normal operation, the , and buttons are not
in use.
· If cooling is activated then you may/will not be eligible for
government grants.
*1 The system is locked to operate without COOL mode. It can
be unlocked only by authorised installers or our authorised
service partners.
*2 Only displayed when COOL mode is unlocked (Means when
COOL mode is available).
AUTO AUTO + TANK HEAT HEAT + TANK TANK COOL + TANK COOL
Operating Instructions (Controller)
1
2
3
P
1
Press the UP or DOWN button to set the current weekday
2
Press the SET button to confi rm the setting
3
Repeat steps 2 and 3 to enter the current time
4
6
UK_MANUAL_B.indd 6
29/07/15 12:18
