Panasonic U-72MF1U9 Скачать руководство пользователя страница 25

Страница: 25 / 128

- 5

Remote Control Functions

2. Wireless Remote Controller

F: FILTER button

If a separately installed signal receiver is being employed, this button is used to turn off its
filter lamp. When the filter lamp has lighted, first clean the filter, and then press the FILTER
button to turn off the filter lamp. When a wired remote control unit and wireless remote
control unit are both used, the filter sign on the wired remote control unit will appear. When
this happens, first clean the filter, and then press the FILTER button on one of the remote
control units to turn off the filter sign.

G: ADDRESS button

When a multiple number of indoor units that can be operated by the wireless remote
control unit have been installed in the same room with a multi-unit or single-unit installation,
this button enables addresses to be set in order to prevent the sending of signals to the
wrong indoor unit. Each of up to six indoor units can be controlled separately using its own
wireless remote control unit by matching the number of the address switch on the operation
area of the indoor unit and the number used for the address of its remote control unit. (The
indoor units cannot be controlled separately when they are used in a flexible combination
format, simultaneous operation of multi units format or any other such format since they will
all operate at the same time.)

NOTE

When the batteries are replaced, the address setting returns to "ALL", so you must make
the setting again.

H: A/C SENSOR button

When you press this button (use a narrow-tipped object such as a ballpoint pen), the

indication will disappear on the display. The room temperature is detected by the sensor
which is built into the indoor unit and the air conditioner is controlled accordingly.

NOTE

If the remote control is located near a heat source, such as a space heater or in direct
sunlight, press the A/C SENSOR button to switch to the sensor on the indoor unit.

I: FLAP button

1. Use this button to set the airflow direction to a specific angle.
The airflow direction is displayed on the remote control unit.

Operation mode

(COOL) or (DRY)
(HEAT) or (FAN)
(AUTO)

Number of airfl ow direction settings

3
5

Cooling mode:

Heating mode:

3
5

CAUTION

In the Cool mode and Dry mode, if the flaps are set in a downward
position, condensation may form and drip around the vent.
Do not move the flap with your hands.

NOTE

This function is available only for models X, XM, A, T and K.

(SWEEP)

2. Use this button to make the airflow direction sweep up and down automatically.

Press this button several times until the

symbol appears on the display.

To stop the swing operation

Press the FLAP button again during the flap swing operation to stop the flap at the desired
position. Then, the airflow can be set from the top position by pressing the FLAP button
again.

SM830202-00̲3WAY VRF.indb 5

2012/01/30 14:52:39