31
Tuning your VCR and satellite receiver
Your new TV is supplied with programme position ‘0’ set to receive an RF signal from your VCR, although a
Scart connection is preferable if the VCR is so equipped (see page 6 or 36 for suitable inputs to the Scart socket
on this TV.)
However, if for some reason your VCR is tuned to a different RF channel then you will not receive any picture or
sound from your VCR on programme position ‘0’ of the TV. Either adjust the tuning of the TV’s programme
position ‘0’ (follow the instructions below) or adjust the RF channel of your VCR (some VCRs allow adjustment of
their RF channel via their remote control unit) or both until the TV receives the RF output channel of your VCR.
It is intended that this advice is used in conjunction with the instruction books for your additional equipment.
Tuning your TV to the VCR.
Switch on the VCR, insert and play a pre-recorded tape with known content
PICTURE
SOUND
SET UP
TV/AV
1
Press
SET UP
.
2
Move to chosen Tuning menu option by using
or
.
3
Access Tuning menu by using
or
.
4
Move to chosen Manual tuning by using
or
.
5
Access Manual tuning by using
or
.
6
Select programme position ‘0’ VCR by using
or
.
7
Start searching for the VCR playback of the known content tape by using
or
.
When the VCR playback is found, pressing
STR
to store.
Pressing
TV/AV
to exit.
Notes:
• If picture patterning occurs on programme position ‘0’ it may be
necessary to adjust the RF output channel of the VCR, refer to the
VCR instruction book.
• If a Satellite Receiver and a VCR are going to be used with RF cable
connections it is important to avoid both units being set on the same
channel.
Refer to the Satellite Receiver and VCR instruction books for precise
tuning information.
Manual tuning
21 68
CH44
VCR
The tape with known content is
found and displayed.
Pressing
STR
will store the
setting.
VCR
