35
English
Note
●
Set [Network control] of all displays to [On]. (see page
55)
●
Depending on the network environment,
synchronization may be largely lost.
●
Do not connect other devices to prevent network
traffic jam.
●
With a router put in between, you cannot set up
connection. Use them within the same subnet.
●
Do not use wireless LAN for connection since
playback may not be performed normally.
Starting / ending Media Player
■
For Single Media Player
Start
1. Insert USB memory for Media Player.
Note
●
Depending on the type of a USB memory
device, it may come in contact with the
periphery such as a back cover, and cannot be
attached. Use a commercially sold extension
cable, or use a small type of a USB memory
device connectable to this unit.
USB
memory
USB
terminal
2. Run a USB memory contents check.
3. Change INPUT to USB.
Ending
Change INPUT to other than USB.
■
For Multi Media Player
Start
1. Connect several units with LAN cables.
(see page 34 "Example of setting up LAN
connection and IP address / Subnet mask")
2. Insert USB memory for Media Player into each
Display.
3. Executes USB memory contents check on
each Display.
4. Change INPUT for Slave to [USB].
5. Change INPUT for Master to [USB].
Ending
Change INPUT for Master to other than [USB]
Resume Play function
After Media Player ends, the file to be resumed when
resuming playing varies depending on the setting of
[USB media player settings] - [Resume play].
When set to [On]:
The file played prior to the end of Media Player starts
playing from the beginning.
When set to [Off]:
Play starts from the beginning of the first file of the
scenario.
Note
●
The resume play function is retained until the unit is
turned off or the USB memory device is taken out.