7
Installation
Caution
Keep batteries out of children’s reach. If batteries are swallowed, contact a physician immediately.
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Observe the following precautions:
1. Always use new batteries when replacing the old set.
2. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
3. Battery replacement is necessary when remote control acts sporadically or stops operating this unit.
1
2
Remote control battery installation
Requires a CR2025 battery
1. Draw out the battery tray by sliding
latch 1 and pulling in the direction
of
2
as shown below.
2. Remove battery as shown below.
Install the battery in the battery tray.
(Confirm that the positive pole
marked “ + ” is facing up.)
3. Replace the tray and slide back the
latch until it snaps in place.
Notes:
•
Do not drop, apply shock to or step on the remote control.
•
Do not spill water on the remote control.
•
Do not place objects between the remote control and remote control receiver.
•
Do not use remote controls for other equipment at the same time.
•
If the TV does not operate even when operating the remote control from a close range, it is time to replace the
batteries (product number: CR2025).
Refer to the label on back of the remote control for directions on replacing batteries.
Remove the insulation sheet.
The lithium battery is included in the
remote control at the time of delivery.
Remove the insulation sheet to
operate the remove control.
“Replacing batteries” label
•
Be sure to use the power cord and AC adaptor (model no. : N0JZHK000003) included in the accessories.
•
Usage of AC adapters other than specified may cause malfunctions.
AC Adaptor installation
Back of the Remote Control
the insulation sheet
Replacing batteries
Replace batteries by following the steps below:
