Recording
37
LSQT1211
To end the recording
Press the recording start/stop button again to pause
recording.
≥
[
¥
] and [
;
] are red during recording. Do not move
this unit until [
;
] is green.
The images recorded between pressing the recording start/stop button to start recording and pressing it
again to pause recording become one scene.
However if the recording destination is the HDD, the scene is automatically divided when the recorded
data exceeds 4 GB. (The recording will continue.)
≥
When about 5 minutes have passed without any operation in recording pause, the unit automatically
turns off to prevent the battery from running down. When you want to use the unit, turn it on again.
This setting can also be set to [OFF]. (
l
90, [POWER SAVE])
A
Recording mode
B
Selected recording destination
C
Remaining time left for recording
(When the remaining time is less than 1 minute, [R 0h00m]
flashes red.)
D
Recording time elapsed
≥
Sound is recorded from the internal stereo microphone on the front of the unit. Take care not to block
this microphone.
≥
If the write protection switch on the SD card is set to LOCK, it cannot be used for recording. (
l
17)
≥
Each time the unit enters the recording pause mode, the counter display will be reset to “0h00m00s”.
≥
While motion picture recording is in progress, the recording will not stop even if the LCD monitor is
closed.
≥
While motion picture recording is in progress, do not disconnect the AC adaptor or remove the
battery. If you do, a repair message may be displayed when the power is turned back on. (
l
95,
About recovery)
Screen indications in the video recording mode
R 12h45m
R 12h45m
R 12h45m
0h00m10s
0h00m10s
0h00m10s
B
A
C
D
SP
LSQT1211(PAL_ENG).book 37 ページ ２００７年２月１３日 火曜日 午後１時１４分
