GB20
GB21
Problem
Cause and Action
When cooking jam, it has
scorched or the kneading blade
fixes and it doesn’t come off.
The amount of the fruit is too little, or the amount of sugar is too much.
➝
Place the bread pan in the sink and half fill the bread pan with warm water. Leave the bread pan to soak until
the cooked on mixture or kneading blade loosens. After scorching is relieved, wash it with a soft sponge etc.
Can frozen fruits be used?
It can be used for only jam.
What kinds of sugar can we use
on jam?
White caster and granulated can be used.
Do not use brown sugar, diet sugar, and low calorie sugar or artificial sweetener.
When making jam, can we use
fruits are pickled in alcohol?
Do not use them. The quality is not satisfactory.
appears on the display.
There has been a power failure for approx. 10 minutes (the plug has been accidentally pulled out, or the breaker
has been activated), or there is another problem with the power supply.
➝
The operation will not be affected if the problem with the power supply is only momentary.
The machine will operate again if its power is restored within 10 minutes, but the end result may be affected.
1 appears on the display and
operation has been stopped.
When the power supply to machine is interrupted for a certain time, the display shows 1 after recovered. (It is
standby mode and machine could not continue the program.)
➝
Remove the bread, dough or ingredients and start again using new ingredients.
H01, H02 appears on the
display.
The display indicates a problem with the machine.
➝
Consult the place of purchase or Panasonic service centre.
U50 appears on the display.
The machine is hot (above 40 °C / 105 °F). This may occur with repeated use.
➝
Allow the machine to cool down to below 40 °C / 105 °F before using it again (U50 will disappear).
During or after cooking
Display exception
Puzzle
The kneading blade rattles.
This is because the kneading blade fits loosely on the kneading mounting shaft. (This is not a fault.)
I can smell burning while the
bread is baking.
Smoke is coming out of the
steam vent.
Unpleasant odours may be emitted during the initial use, it will not emit again under normal operation.
Ingredients may have been spilt on the heating element.
➝
Sometimes a little flour, raisins or other ingredients may be flicked out of the bread pan during mixing.
Simply wipe the heating element gently after baking once the machine has cooled down.
➝
Remove the bread pan from the main unit to place ingredients.
Dough leaks out from bottom of
the bread pan.
A small amount of dough will escape through the ventilation holes (so that it does not stop the rotating parts from
rotating). This is not a fault, but check occasionally that the kneading mounting shaft rotate properly.
➝
If the kneading mounting shaft does not rotate when the kneading blade is attached, you will need to replace
the kneading mounting shaft unit. (Consult the place of purchase or Panasonic service centre.)
(Bottom of bread pan)
Ventilation holes (4 in total)
Kneading mounting shaft
Part no. ADA29E1651
Kneading
mounting shaft
Kneading
mounting shaft unit
Troubleshooting
Specifications
Disposal of Old Equipment
Only for European Union and countries with recycling systems.
This symbol on the products, packaging, and
/
or accompanying documents means that used electrical and
electronic products must not be mixed with general household waste.
For proper treatment, recovery and recycling of old products, please take them to applicable
collection points in accordance with your national legislation.
By disposing of them correctly, you will help to save valuable resources and prevent any potential
negative effects on human health and the environment.
For more information about collection and recycling, please contact your local municipality.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.
Power supply
230 V 50 Hz
Power consumption
700 W
Capacity
(Strong bread flour)
max. 500
g
min. 300
g
(Dry yeast)
max. 7.0
g
min. 2.1
g
(Baking powder)
max. 13.0
g
min. 10.0
g
Timer
Digital timer (up to 13 h)
Dimensions (H × W × D)
Approx. 34.0 × 27.3 × 40.4 cm
Weight
Approx. 7.0 k
g
Accessories
Measuring cup, measuring spoon
English
SD-ZP2000 EN_DE_OI5.indd 20-21
16/7/2018 20:00:43
