Simple setup
7
RQT7705
Simple setup
Locating
•
Use only supplied speakers
Using other speakers can damage the unit and sound quality
will be negatively affected.
•
Set the speakers up on an even surface to prevent them from
falling. Take proper precautions to prevent the speakers from
falling if you cannot set them up on an even surface.
Caution
•
Use the speakers only with the recommended
system. Failure to do so may lead to damage to the
amplifier and/or the speakers, and may result in the
risk of fire. Consult a qualified service person if
damage has occurred or if you experience a sudden
change in performance.
•
Do not attach these speakers to walls or ceilings.
Positioning for best effect
How you set up your speakers can affect the bass and the sound
field. Note the following points.
•
Place speakers on flat secure bases.
•
Placing speakers too close to floors, walls, and corners can
result in excessive bass. Cover walls and windows with a thick
curtain.
•
Keep your speakers at least 10 mm away from the system for
proper ventilation.
Notes on speaker use
•
You can damage your speakers and shorten their useful life if
you play sound at high levels over extended periods.
•
Reduce the volume in the following cases to avoid damage.
–
When playing distorted sound.
–
When the speakers emit strange noise (howling) from a
microphone or record player, noise from FM broadcasts, or
continuous signals from an oscillator, test disc, or electronic
instrument.
–
When adjusting the sound quality.
–
When turning the unit on or off.
If irregular coloring occurs on your television
These speakers are designed to be used close to a television,
but the picture may be affected with some televisions and set-up
combinations.
If this occurs, turn the television off for about 30 minutes.
The television’s demagnetizing function should correct the
problem. If it persists, move the speakers further away from the
television.
STEP
1
Place the speaker so that the super tweeter is on the outside.
Connecting the speakers and voltage selection
STEP
2
Twist and pull off the vinyl tip of the speaker cords.
Right speaker
R
L
AC IN
COMPONENT
VIDEO OUT
VIDEO
OUT
S VIDEO
OUT
P
R
P
B
Y
FM ANT
VOLT ADJ
AM ANT
SPEAKERS
GND
LOOP
EXT
AUX
LINE
OUT
(75
Ω
)
R
L
VOLT ADJ
127 V 110 V 220-230 V 240 V
220
I V
230
Connect the left (L) side in
the same way.
Before connecting the AC power
supply cord, set the voltage.
Voltage Selector
Use a flat-head screwdriver to turn the
voltage selector on the rear panel to the
appropriate position for the area in which
this system is used.
If the power supply in your area is 115 V or
120 V, please set the voltage selector as
follows:
For 115 V: Set to 110 V.
For 120 V: Set to 127 V.
For the Middle East, South Africa,
Southeast Asia, Saudi Arabia and Kuwait
Red (+)
2
1
+
L
R
3
+
Red
Black
Black ( )
Super tweeter
Note
You cannot take the front net off the speaker.
RQT7705(07-11)_29
23/3/04, 14*48
7
