Operations
11
TQBS0132
Bluetooth
®
connection
By using the Bluetooth
®
connection, you can listen
to the sound from the Bluetooth
®
audio device
from this system wirelessly.
≥
Refer to the operating instructions of the Bluetooth
®
device
for further instruction on how to connect a Bluetooth
®
device.
Preparation
≥
Turn on the Bluetooth
®
feature of the device and
place the device near this system.
1
Press [ ] to select “ ”.
≥
If the “
” indicator flashes quickly, go to step 3.
2
Press and hold [ ] until the “ ” indicator
flashes quickly.
≥
If the “
” indicator flashes slowly, repeat step 2.
3
Select “SC-SB1” from the Bluetooth
®
device’s Bluetooth
®
menu.
≥
If prompted for the passkey on the Bluetooth
®
device,
enter “0000”.
≥
Once the Bluetooth
®
device is connected, the “
”
indicator stops flashing and lights up.
≥
You can register up to 8 devices with this system. If a 9th
device is paired, the device that has not been used for the
longest time will be replaced.
1
Press [ ] to select “ ”.
≥
If the “
” indicator lights, a Bluetooth
®
device is
already connected with this system. Disconnect it.
(
>
below)
2
Select “SC-SB1” from the Bluetooth
®
device’s Bluetooth
®
menu.
∫
Disconnecting a Bluetooth
®
device
Press and hold [ ] until the “ ” indicator flashes.
≥
This system can only be connected to one device at a time.
Advanced operations
This system is automatically turned off if there is no audio
input and when you do not use it for approx. 19 min and
30 sec.
1
While pressing
and holding
[
i
SUBWOOFER]
on the remote control, press and hold
[VOL
s
] on this system for more than
4 sec.
≥
The current mode will be indicated by the
corresponding LED indicator.
2
While the current mode is indicated (about
20 sec), press [
i
SUBWOOFER] again.
≥
The setting changes each time [
i
SUBWOOFER] is
pressed.
≥
The indicator for the selected setting blinks for 20 sec and
then exits the setting mode.
≥
The setting is maintained until it is changed again.
≥
Default setting of this function is “On”.
This function allows you to connect a paired Bluetooth
®
device when this system is in standby mode.
1
While pressing
and holding
[SUBWOOFER
j
]
on the remote control, press and hold
[VOL
s
] on this system for more than
4 sec.
≥
The current mode will be indicated by the
corresponding LED indicator.
2
While the current mode is indicated (about
20 sec), press [SUBWOOFER
j
] again.
≥
The setting changes each time [SUB WOOFER
j
] is
pressed.
≥
The indicator for the selected setting blinks for 20 sec and
then exits the setting mode.
≥
The setting is maintained until it is changed again.
≥
Default setting of this function is “On”.
Bluetooth
®
pairing
Connecting a paired Bluetooth
®
device
Auto Power Down
Bluetooth
®
Standby
“On”
“Off”
“On”
“Off”
(11)
SC-SB1_EG_TQBS0132.book 11 ページ ２０１７年４月２１日 金曜日 午後３時３２分
