VQT2R75
7
Installing and assembling the system
Installation
Setup
example
This system
•
At least 2 people are necessary for
lifting up the system.
•
Use a phillips-head screwdriver.
(Do not use an electric screwdriver.)
•
Avoid unstable places. Choose a flat
location for installation.
•
Handle the glass doors with enough
care.
• Take adequate measures to prevent the TV from
falling down. Make sure to set the caster trays
when the casters are attached.
• You can install this system so that it is flush with
the wall at the back. (Depending on the depth of
equipment to install or the type of cable, installing
this system flush with the wall may be impossible.)
• Do not place in front of curtains as they may
obstruct the system’s exhaust hole.
• If the surface of the wooden floor is soft, the caster
mark may remain.
• Do not put anything but a TV on the top board of
this system.
Do not put the following things in particular.
x
Putting a hot thing may leave the mark and it
may not come off.
x
If you put a vase with water in it and when it falls
down, the water may splash over this system
and this can cause malfunction.
Front side
Soft
cloth, etc
6
✽
1
6
✽
2
Cushion
Hold and pull
Caster
(Bottom plate)
2
Place your other hand under the bottom of the
front side and lift the system up keeping it
horizontal.
How to lift the system
Removing casters
1
Tilt the system forward slightly then place your
hand under the bottom of the back side.
Front side
Back side
• Do not put anything on and in the system when
removing casters. (You do not need to remove the
amplifier and speakers as they are fixed.)
• Remove the casters on soft floor materials
(i.e. thick-piled carpet, etc.).
• To remove the casters, place the cushions
(
indicated with
6
✽
1 and
6
✽
2 on page 4,
packing plan) used at both ends of packaging, and
place this system with its back side facing down on
them.
Connection
Installing and assembling the system
